I started with a strip of aluminum that was about the same width as the keys i was using, sex bolts, and washers (Brass)
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/Parts-1.jpg)
Then i cut the aluminum into equal sized pieces to hold the keys in between them
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/UnpaintedAluminum-1.jpg)
At this point i have made 3 but my most recent one i did i painted
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/PaintedAluminum-1.jpg)
Then i cut the keys for my van and shaved them down to fit flush with the aluminum pieces
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/TheKeys-1.jpg)
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/TheCutKeys-1.jpg)
Finally i put it all together along with my house key that i also shaved down and this is the final product
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/FinalClosed-1.jpg)
![Image](http://i1236.photobucket.com/albums/ff443/lockboy1691/keys/FinalOpened-1.jpg)