Page 2 of 2

Re: Just placed an order on an Interceptor.

Posted: Sat Mar 05, 2011 10:50 am
by e7ats
Bump for Logan
Here is the web site. AeroForce Tech/ Interceptor

This gauge has been great. There has been times I've had a random miss fire and the SES Light would start blinking and go out. I can pull the code with a few button pushes and clear it. Currently I have it set to scroll though 4 screens and each screen has 2 readings. On each screen I have the MPH. then the bottom I have Engine temp, Transmission temp, Engine RPM, and Battery voltage. I hate to say it, but I haven't changed the way it is installed. Still sitting on the dash with double sided tape holding it. :rolleyes:

Typical driving I can see anywhere from 125-150F on trans temps. When pulling I can go up to 210 with AC running. I try not to let it get above this point.

Re: Just placed an order on an Interceptor.

Posted: Sat Mar 05, 2011 5:16 pm
by 78si
Did you have to add a transmission temperature sensor?

Re: Just placed an order on an Interceptor.

Posted: Sat Mar 05, 2011 6:17 pm
by e7ats
No. IIRC From 96 on the Transmission temp sensor was standard on these vans. It was part of the OBDII standard that came out. This gauge reads all its data from the ECM (Computer).