Chevy & GMC Vans

Here is a short clip of the dash in action.

https://www.facebook.com/photo.php?v=46 ... 0721668215

Very nice. Ya done good.

Smiliesafari wrote:Very nice. Ya done good.

Thank you

Sure was hard work to make this conversion possible. sure wasn't easy

So here is an update of my progress.

**********VIDEO**********
https://www.facebook.com/photo.php?v=46 ... 6848770085
***************************

So for whoever that are doing what i did? especially when it comes with a oil pressure sensor is where i wasted most of my time. As this van was under KPA for the oil pressure and the new gauge was under PSI. so my original sensor would throw a false signal, so i T the line to put my original sensor and added the Aux "from Autometer" on the other end of the T fitting so that i can connect my PSI oil gauge so that i can finally have a good reading as previously, it was throwing a 100 PSI and the gauge would flash whenever i stop.

So USE the sensor if you are upgrading. just food for thought so that you wont waste your time like i did.

I dont see an SES light, or a Highbeam indicator.
Did I miss that part?

doyoulikeithere wrote:I dont see an SES light, or a Highbeam indicator.
Did I miss that part?

no it is there i'll send you the vid here.


**********Video*******
https://www.facebook.com/photo.php?v=46 ... 6848770085


Video 2 of today's drive

https://www.facebook.com/photo.php?v=46 ... 5107566007

It is also in the pic top row between the green leds? you'll see a white led ? that is my High beam

on the bottom row, between the 2 red leds? far left is my Batt warning light, far right is my Break and in the middle is my SES "Amber led"