By far the simplest dent repair

peter · Post by **peter** » Sat May 12, 2007 4:47 am

http://www.metacafe.com/watch/501379/re ... airduster/

Infreakin'credible

BLAZER · Post by **BLAZER** » Sat May 12, 2007 6:47 am

I've seen it doen with a heat gun and ice. You basically expand the metal then instant cool it which causes shrinkage casuing the dent to pop out. Won't work the best though if there is a crease. It kind of works like Peter getting out of a warm hottub and then running through the snow to the house....things shrink up really fast

$\:D/$

Water Boy · Post by **Water Boy** » Sat May 12, 2007 8:42 am

Is this the technic that those mobile paintless dent repair people use?

peter · Post by **peter** » Sat May 12, 2007 3:10 pm

BLAZER wrote:I've seen it doen with a heat gun and ice............ It kind of works like Peter getting out of a warm hottub and then running through the snow to the house....things shrink up really fast $\:D/$

Did I ever mention how much I hate you?

BLAZER · Post by **BLAZER** » Sat May 12, 2007 4:44 pm

you really love me, just admit it!!!

CaptSquid · Post by **CaptSquid** » Sun May 13, 2007 4:56 pm

I dunno, Blazer. I have it on good authority (Al and Roswell) that Peter doesn't have to run through the snow to achieve that state.

peter · Post by **peter** » Mon May 14, 2007 2:31 am

Well, time to look for yet ANOTHER site to frequent.....

astrozam · Post by **astrozam** » Mon May 14, 2007 9:25 am

Cool vid Peter,thanks for posting

Rileysowner · Post by **Rileysowner** » Mon May 14, 2007 8:28 pm

I was going to try this today, but couldn't find the spray they use. I used to be able to find it all over, but not any longer. Walmart has a device that uses CO2 cartidges but I am not too sure about spaying liquid CO2 on my van

peter · Post by **peter** » Tue May 15, 2007 3:14 am

Same thing, bud. As long as the liquid being sprayed is freezing cold and non-corrosive, you should be fine. Heck, Butane'd work fine too, 'specially with a lit cigarette hanging from your lip $\:D/$

astrozam · Post by **astrozam** » Tue May 15, 2007 6:48 am

peter wrote:Same thing, bud. As long as the liquid being sprayed is freezing cold and non-corrosive, you should be fine. Heck, Butane'd work fine too, 'specially with a lit cigarette hanging from your lip $\:D/$

ROFLMAO

peter · Post by **peter** » Wed May 16, 2007 5:37 pm

Yeah, I still gots it, huh Keith?

astrozam · Post by **astrozam** » Wed May 16, 2007 7:42 pm

peter wrote:Yeah, I still gots it, huh Keith?

Yep,your not dead yet,lol

BLAZER · Post by **BLAZER** » Fri May 18, 2007 2:38 pm

Rileysowner wrote:I was going to try this today, but couldn't find the spray they use. I used to be able to find it all over, but not any longer. Walmart has a device that uses CO2 cartidges but I am not too sure about spaying liquid CO2 on my van

Just get a can of compressed air used to clean off keyboards, etc. Turn it upside down when spraying and it will do the same thing. Most office supply stores or maybe Wally world will carry it.

Rileysowner · Post by **Rileysowner** » Fri May 18, 2007 4:00 pm

I couldn't find it at walmart or the other places I looked. All Walmart had was the device that uses those little co2 cartidges. That is what they now sell to clean keyboards. It also has the warnings about turning it upside down, but as I mentioned spraying actual liquid co2 on the van somewhat concerns me. I will have to keep looking though.

Chevy & GMC Vans

Chevy & GMC Vans

By far the simplest dent repair

By far the simplest dent repair