Check Gauges

Someone · Post by **Someone** » Wed Sep 20, 2006 8:33 am

This may be a dumb question but I have not had time to check yet, but when I turn a corner or brake hard my check gauges light comes on threw the turn and my oil pressure gauge drops to zero, as soon as I am out of the corner it goes back to normal.... Am I most likely just low on oil? I have no leaks and no ticks... I guess I could be just a little low, I am passed my scheduled oil change so it should be done soon anyways... just wondering if it could be something else.... It is time I start working some of the generals bugs out before they infest

v8famvan · Post by **v8famvan** » Wed Sep 20, 2006 10:13 am

Check your oil level, pronto.

Someone · Post by **Someone** » Thu Sep 21, 2006 9:51 am

well ,I changed my oil last night (what weas left of it) and found out I have a small leak at the front of the pan that I am going to have to investigate a little further.... but to my dismay I also found out that what I thought was my trans crossmember that bottoms out on speedbumps is actually my oil pan!!! Time to be extra catious from now on... it looks like there is only enough left for a few more scrapes!!... it has oil on it because I took the pictures after the oil change

Someone · Post by **Someone** » Thu Sep 21, 2006 10:53 am

Is there a shallow pan available for the 4.3?

v8famvan · Post by **v8famvan** » Thu Sep 21, 2006 12:30 pm

Umm, thats not good!

So I guess the check gauges light was coming on because you were low on oil?
I don't think there is such a thing as a shallow pan. You really do have to be careful with these oil pans because they are cast aluminum & they don't really have any give to them like the stamped steel ones. These ones just shatter.

Someone · Post by **Someone** » Thu Sep 21, 2006 12:38 pm

well if there is no shallow pan I will have to adapt a skid plate... wich sucks because it willl be even lower

I only ever touch anything off of a bounce... I really need to find a way to stiffen these t-bars

ds99 · Post by **ds99** » Fri Sep 22, 2006 12:37 pm

Have you tried to re-index your tosions?
I did that with my toyota truck when I was that low and it kept the ride feeling stock but at a much lower stance.
Pull the torsions and fit them in the doglegs? at a different reference position.

brianj · Post by **brianj** » Fri Sep 22, 2006 5:57 pm

Tristan,

Do you still have some of the left over timbren parts? Could you stuff part or all of a timbren in place of the factory bump stop? You are likely riding on or pretty close to it now, why not beef it up?

I'd get an oilpan from the junkyard, or somebody here, and take it to a welding shop, and have them section out about an inch or so. Just be sure to know exactly how much so you take the same amount out of the pickup.

just my suggestions....

bri

Chevy & GMC Vans

Chevy & GMC Vans

Check Gauges

Check Gauges