Page 1 of 1

Well guys I did it.

Posted: Tue Jan 27, 2015 6:11 pm
by 1Gary
I've always want to have both a cherry picker and a gantry lift to swap out the 4.3 and a second sub frame for 383 V8 to put it back in the Ole Yellar van.I've had the cherry picker all along and tonight I bought this:

Image

What that means is while I'll use the cherry picker to lower the sub frame,4.3 engine,and tranny,I will be lifting the van by a strap on the rad core support which means I can freely roll the sub frame from the van.The sub frame for the 383 set-up which is the second one I have is going to the sand blaster to be first cleaned up and then have the pipe lift welded to it.Pix's to follow.

Re: Well guys I did it.

Posted: Tue Jan 27, 2015 7:03 pm
by Herbie
Awesome. I'm very jealous.

Re: Well guys I did it.

Posted: Wed Jan 28, 2015 7:41 am
by mdmead
Sweet!

Re: Well guys I did it.

Posted: Wed Jan 28, 2015 8:33 pm
by T.Low
:supz:

Re: Well guys I did it.

Posted: Thu Jan 29, 2015 9:25 am
by Smiliesafari
Nice unit, Gary. When I built my shop I welded an I beam over each bay. Since you rent that was a good choice.

Re: Well guys I did it.

Posted: Fri Jan 30, 2015 11:21 am
by Meterpig
I see those at the pick and pulls. Very, very handy.

Re: Well guys I did it.

Posted: Fri Jan 30, 2015 7:53 pm
by doyoulikeithere
Glad to see you being busy again Gary :)
That unit will be the cats ... for your project.
Hope to hear a sound clip of your 383 purring in Ol Yellar this summer !
:cheers:

Re: Well guys I did it.

Posted: Fri Jan 30, 2015 10:10 pm
by 1Gary