Hi
I am trying to find a PCV grommet for a 1981 GMC Vandua IL6 250CI. I find a few different ones on the Internet bu not sure which is the proper...

2010 V8 Engine EFI

Do not be alarmed by the test posts. I'm just figuring out some forum config stuff. Thanks for your patience.

MMJ

yabbadabbadoo

hurry gurdy goo

testing user interface

Hi guys. Just an FYI.
A Discord server for Astro/Safari vans has been launched by Will.

Discord is a sort of like the chat rooms of the 90's, but...

Stock bumper brackets

Could be useful for fabbing some custom frame mounted things.
Or you could use it for a poor man's lift kit.
Rust is...

vacuum hose routing for HVAC system on a 1990 G Van (similar on most years of that era)

I snapped a few pics during pan service today. 80,000 km

(More info in the gallery album )

:-k I've seen fit to draw up a new contingency powertrain for my M11006. Ford Motor Company used to manufacture high-pinion 8 axles for the F-100,...

I unearthed a scattered trove of neglected photo galleries. So I assembled them together, and gave them some fresh software. They are now viewable by...

Hi folks.

I had a big idea for our Forum, and I want to run it by you for opinions. I am thinking about expanding this Forum to include the...

Michelin LTX M/S TIRES
(recovered from archives)

This will be a review of the Michelin LTX M/S tire sized @ 215/75/15 ( 27.6 ) which are classed as...

The controller on my electric fans is malfunctioning and I am about to replace it.

The replacement control unit I have on hand has a temperature...

Hey guys,

I've recently acquired a '98 Astro LT 2WD. It's a Japanese export model (not that there's a world of difference) and I've set about...

So I recently swapped from barn doors to dutch doors then I had the problem of where to put the spare tire. Before I swapped the rear doors I did...

:-k My issue GMC M11006, I found to my chagrin, has an incorrect and porous hose, apparently a Hydro-Boost-to-gear hose with the high flare elbow cut...

AstroSurf!

1997 Custom Astro -

- 4 Drop Spindles
- 4 Drop Leaf Springs
- Rear Roll Pan
- Lime Squeeze Green Metallic and Cool Vanilla Paint
-...

My 2001 GMC Safari SLT suffers from rust right behind the sliding door front of rear wheel well I cannot find much in replacement panels for this...

I’ve checked the Notify me when a reply is posted button on each of my posts and so far I have yet to be notified, either by pop-ups or email. If...

I’d really like to connect with anyone else nearby. As you can see by my signature I’m on my 3rd and learning more with each one but I could use some...

delete a post or delete your account ? I never did get an answer and now my email account gets flooded with SPAM.

Hi! Seems it's common to have the problem that when you shift from P to gears, the engine stalls. Me, it's exactly the opposite. It's when I shift...

Hi! Seems it's common to have the problem that when you shift from P to gears, the engine stalls. Me, it's exactly the opposite. It's when I shift...

Just the Dad of a cool kid who wanted a camping van . so here we are. Hes 19 found a short term dream helping him live it. he bought a 1999 astro AWD...

On my '98 ( which i have only had for about 10 months), at the top of the hatch on the dutch ( 3 dr) door setup, there is a single weatherstrip...

Good Afternoon,

Anyone know of a source for pre-bent brake lines for a 2002 Astro 2 WD? Also - for the installation do I have to remove the fuel...

a user for a specific town?

1996 Safari, intermittent no starter crank.
Appears to be a bad neutral safety switch,
sometimes will start when in neutral.
Would like to install a...

Hello
I would like to know if it is possible to replace the engine by the 4.2 engine of 97 by a motor astro van 93 which must be done so that it...

I broke the plastic harness off the original on my '94 Safari and replaced with a BWD WT300 - the code is reading 15 (indicating a problem with the...

I have seen references in the GM wiring diagram for my '98 Astro, which seem to refer to 'Early' and 'Late' versions.
Mine is a March '98 version...

2003 Astro AWD LT, 156k miles. Within the last 2 weeks, the blower resistor failed, followed (almost immediately after replacement) by the blower...

Replacing the fuel tank pressure sensor fixed my long-standing P0446 code. It was a 10 minute fix since I have cut an access hatch in the floor of...

Just curious if anyone ever thought about adding gen 1 and gen 2 sections for specific ideas pertaining to them categories?
Also if you still need...

2000 chevy astro van with strange vibration. Pretty vague question but it vibrates at idle so bad it will spin a coffee cup in the cup holder. At...

So I have a '04 Astro AWD with about 110k miles on it. I've owned it for ~2 years or so, and it has never gotten very good gas mileage - typically...

I am replacing my upper control arms complete with bushings and ball joints. When reattaching the ball joint to the steering knuckle (spindle?) how...

I've been wanting to do some body graphics for awhile. The large ones (wraps) are awesome, but so expensive. I keep seeing businesses, such as moto,...

On the highway this morning. Hit a pothole and right away engine light starts flashing. The van was idling rough when I stopped. Reader gave a...

Recently I have noticed that if I don't warm the van up before driving off, the van would idle rough and make a rattling sound when stopped at a...

The throttle cable in my 95 Safari is fraying on the throttle body side (at least, could be even worse than what I can see). Right now the stickiness...

My 1995 AWD Safari starts almost instantaneously when cold, but re-starting after the engine has reached normal operating temperature is much more...

The manual calls for a J-29193 tool to set the idler arm taper before putting on the castle nut. I haven't taken the old arms off yet to know exactly...

This is the second time and I'm stumped. On my way home from a trip to New York the coil decided to quit. A flat bed trip to a shop and coil...

OEM is the best shaft. If you look at remanufactured you will usually see they are rebuilding stock units. The steel in new aftermarket units can be...