Had a problem on the weekend where after moving the van for the first time in two weeks, the brake lights stayed on dimly. Well eventually I found the cause. Thought I would share it, would be a good idea to take a quick peak if you have a connector like this. On the new one I covered everything in dieletric grease so the water can't attack it again.
Had quite a smell too, although at first I just assumed it was the exhaust since it had been sitting so long. Well it wasnt!
That wire that is missing was complete eaten away from corrision. Thats the orange wire.
Hope this might save someone some agrivation. The orange wire is fed from the front underhood fuse panel with a 30 amp fuse. Thats where the feed for keeping the lights came from. But if I hadnt found the cause I wonder what would have happened if it melted more!
Scott
Trailer wiring melted!
Re: Trailer wiring melted!
Holy Crow Scott!!!.Any chance to install a in line fuse closer to the plug??.You sure have me thinking about one now.
1979 Malibu drag race only car
1999 Sonoma 4.3 5 speed-Rufus
1989 Astro-Ole Yellar cancelled-still selling off parts
1985 Astro-shop van R.I.P. my friend
1994 Astro LT RWD W4.3 rod knock RIP
1982 Winnebago single rear wheel-Chevy 350 Scraped 1/28/13-broken dreams......
Rochester,NY
1999 Sonoma 4.3 5 speed-Rufus
1989 Astro-Ole Yellar cancelled-still selling off parts
1985 Astro-shop van R.I.P. my friend
1994 Astro LT RWD W4.3 rod knock RIP
1982 Winnebago single rear wheel-Chevy 350 Scraped 1/28/13-broken dreams......
Rochester,NY
Re: Trailer wiring melted!
Good find. I might have encapsulated the wires in a silicone though. Do you have a pic of the repair? Again Thanks for sharing. Jim
Re: Trailer wiring melted!
I have seen that happen on all of our trucks at work. It was so bad on our F650 it melted the entire trailer fuse/relay box ( the F650s have a seperate fuse/relay box for the trailer stuff). The round 7-ways seem to have an issue with that. We tried Die-elec grease but we use them so much that it still happens. The weather covers don't seem to keep any crap out either. I have opened them before and found chunks of rock salt in the connector.
What we have taken to doing in the winter when we don't use them except on a few select trucks is to remove em and enclose the wiring.
What we have taken to doing in the winter when we don't use them except on a few select trucks is to remove em and enclose the wiring.
98 Safari RWD. Stock.
Do you smell what Barack is cookin ?!?!
Do you smell what Barack is cookin ?!?!
-
- I have my van tatooed on my cheeks
- Posts: 4379
- Joined: Sat Sep 09, 2006 3:35 pm
- Location: New Haven, NY
Re: Trailer wiring melted!
Yup, had that happen on the SPB once while at Lockdoc's house. At first I thought the brakes were sticking but then as I walked around the rear, I saw the smoke.
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition
Mileage spreadsheet
Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition
Mileage spreadsheet
Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
-
- ASV Supporter
- Posts: 2667
- Joined: Sat Dec 02, 2006 12:34 pm
- Location: Orlando, FL
Re: Trailer wiring melted!
Excellent post, Scott. Thanks. I can't tell you how many of those connectors I've had to replace on the vehicles and trailers at the landscape company. Even here in Florida they corrode quickly. I'm glad your vehicle didn't sustain any damage.
1996 Safari SLX Hotair balloon transport vehicle
-
- I sleep in my van
- Posts: 682
- Joined: Mon Sep 29, 2008 8:35 am
- Location: Victoria B.C.
Re: Trailer wiring melted!
I too have had the same issue, must be a crappy design.
On my pickup I moved the plug-in to the front of the box, on the inside. Then I extended the wire on the trailer so it can reach the front of the box.
This keeps it out of the weather and away from the road grime. Haven't had a problem with it since.
Peter
On my pickup I moved the plug-in to the front of the box, on the inside. Then I extended the wire on the trailer so it can reach the front of the box.
This keeps it out of the weather and away from the road grime. Haven't had a problem with it since.
Peter
Re: Trailer wiring melted!
Smiliesafari wrote:Excellent post, Scott. Thanks. I can't tell you how many of those connectors I've had to replace on the vehicles and trailers at the landscape company. Even here in Florida they corrode quickly. I'm glad your vehicle didn't sustain any damage.
Hey I work in that industry :P I'm convinced in the summer it's the grass clippings / fertilizer and winter well winter is obvious.
98 Safari RWD. Stock.
Do you smell what Barack is cookin ?!?!
Do you smell what Barack is cookin ?!?!
-
- I get chills without my van.
- Posts: 69
- Joined: Wed Jan 28, 2009 3:12 pm
- Location: Brighton. Michigan
Re: Trailer wiring melted!
I just wired the seven conductor jack on my 2003 AWD Astro. It has the tow package. I wired the turn & running lights through a flat four, inside the jack box, so I can disconnect them when not in use. Just before I cut the wires to length, I checked the 12V (orange) wire - it was hot!!! I unplugged it at the block by the driver's left foot, and will leave it unplugged when not in use. I suspect that the corrosion problems seen in the jacks at the rear bumper are due to the combination of the miserable, wet, salty environment and the 12V + ground left on full time. I did my best to keep out the weather, used dielectric grease inside the connector, and will leave the lights and power disconnected when not in use. I'll give a corrosion report after the next Michigan winter.