how much

chinnesse · Post by **chinnesse** » Thu Jul 26, 2007 9:28 pm

how much play it should have between the difirential and driveshat . thats normal .

Thanks

LiftedAWDAstro · Post by **LiftedAWDAstro** » Fri Jul 27, 2007 5:25 am

There should be no play at all. If the pinion (the part of the rear axle the driveshaft bolts to) has any play it needs to be looked into ASAP. It could be bad bearings or a loose pinion nut.

chinnesse · Post by **chinnesse** » Fri Jul 27, 2007 6:08 am

Replaced pinion bearing last weekend so it should be tight turn both sides . Any other ideas of what the problem could be. and how bad is this .

LiftedAWDAstro · Post by **LiftedAWDAstro** » Fri Jul 27, 2007 6:28 pm

If you just replaced the bearings, did you replace the crush sleeve and properly torque the pinion nut? Sounds like the pinion nut needs to be tightened.

chinnesse · Post by **chinnesse** » Fri Jul 27, 2007 8:39 pm

Only pinion bearing and seal dont have a tork rench any ideas how tight should it be. :-({|=

LiftedAWDAstro · Post by **LiftedAWDAstro** » Sat Jul 28, 2007 2:32 am

Tighten it up until the play is out of it and then go just a little bit more. Run it for a short drive and check it again.

chinnesse · Post by **chinnesse** » Sat Jul 28, 2007 6:18 am

dose anybody know torch specks going to get an inexpensive one.

LiftedAWDAstro · Post by **LiftedAWDAstro** » Sat Jul 28, 2007 10:33 am

In order to torque the pinion nut correctly, you MUST remove the wheels, brake drums, axle shafts, and carrier. Once the carrier is out, you need to pull the pinion nut off, remove the yoke and remove the pinion and install a new crush sleeve. Once the new crush sleeve is installed, you can then re-install the pinion and tighten the yoke down until you get 6 to 10 inch pounds while spinning the pinion over. Gently tap the pinion with a hammer to make sure the bearings are set and you don't get a false reading.

chinnesse · Post by **chinnesse** » Wed Aug 01, 2007 8:00 pm

how hot should the difirential cover get. =; any ideas

LiftedAWDAstro · Post by **LiftedAWDAstro** » Thu Aug 02, 2007 4:53 pm

it can get quite hot especially if towing. I would say 200 degrees F would be normal under some hard driving.

chinnesse · Post by **chinnesse** » Thu Aug 02, 2007 5:16 pm

It was hot just didnt know it got that hot.

I changed the universal joint and the some of the sound and vibration went away . Still have a bit of noise took it to a local mechanics said the noise might be normal.

Thank all for the help. $\:D/$

Chevy & GMC Vans

Chevy & GMC Vans

how much

how much

it has play

only pinion

any body knows what

how hot does differential cover

thanks it was hot