hard steering
hard steering
My 1995 safari developed hard steering after I replaced the cooler return line from the power steering to the pump. I replaced one idler arm all the rest of the steering linkage seems okay would worn ball joints cause this they seem okay? I was wondering if I had to bleed that system after I changed that cooler line?
-
- I have my van tatooed on my cheeks
- Posts: 4379
- Joined: Sat Sep 09, 2006 3:35 pm
- Location: New Haven, NY
Re: hard steering
Make sure the hose isn't kinked. If the ball joints and tie rods haven't been greased, they definitely could cause hard steering. To bleed the lines, jack the van up so the tires are off the ground and rotate the steering wheel back and forth lock to lock about 20 - 30 times. Do this with the engine off. Keep an eye on the fluid level while doing this. If there are a lot of air bubbles in the fluid, let it sit for a few minutes before starting the engine.
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition
Mileage spreadsheet
Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition
Mileage spreadsheet
Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy