Page 1 of 1
towing van
Posted: Sun Nov 19, 2017 12:22 pm
by pakraus
if I install the nc233 transfercase, am I correct in thinking I can flat tow the van with the new case in neutral? any advice appreciated.
Re: towing van
Posted: Sun Nov 19, 2017 6:12 pm
by Snowgeek
I am not the expert on this but I think you are thinking through that correctly. You will still be running the axles, front and rear diff and drive lines but that would be it.
Ryan
Re: towing van
Posted: Mon Nov 20, 2017 9:39 am
by Herbie
NP233 case doesn't have a neutral position.
(This caught me out too, when I first installed mine.)
You can see
this thread where Dean (LiftedAWDAstro) did the initial conversion from Electronic-shift to Cable-shift. That T/C and shifter is now in my van. There's no Neutral, just 2Hi, 4Hi, 4Low.
If flat towing in neutral is important to you, look at the NP231 or other variants.
There are caveats to flat-towing with the NP231 also, but they're manageable:
http://www.fourwheeler.com/how-to/trans ... case-tech/