Page 1 of 1
Cat install
Posted: Sat Nov 25, 2017 6:46 pm
by macsveen
I'm looking for feedback on exhaust install.
I have a direct fit Magnaflow CARB cat 2.50 going into a 2.25 Super 44.
Which way do I install the cat? It has a bend to it. I can point it towards the driveshaft or towards the passenger side.
Re: Cat install
Posted: Wed Nov 29, 2017 7:30 pm
by Snowgeek
I really don’t know the answers here but I will tell you that we are all picture freaks around here and pictures will help those with the answer see what you are talking about and describe the solution the esiest.
On many exhausts and I would assume some cats there is an arrow for direction of flow or an in and out designation..... do you see anything like that.
Ryan
Re: Cat install
Posted: Thu Nov 30, 2017 12:12 pm
by AstroWill
Post up a picture or the actual part number, would make it a lot easier to answer your question.
Re: Cat install
Posted: Thu Nov 30, 2017 7:03 pm
by Stroverlander
Usually they have an arrow or flow direction if it matters. If it's just a usual cat design, not sure it matters. Maybe call or email Magnaflow.
Re: Cat install
Posted: Thu Dec 07, 2017 8:25 am
by Smiliesafari
Are you going to use the original cat back exhaust? Everything from the cat to the rear end.