Does anybody have a picture of there factory exhaust where it connects to the muffler? I have a gibson catback with a flange on the end,but my factory exhaust just has a piece of pipe clamped to the muffler.
Here is a pic of the gibson
Think i should just cut flange off gibson and clamp system on or get another piece of pipe with a flange and mount the exhaust that way?
I think they must have changed them in 1996 for OBD-2. My 98 had the mating flange but the 95 did not. I would get the Gibson in position and cut the stock pipe so you can clamp, or better yet, weld the pipes together.
You could always try to find the flange and weld it onto the stock after-cat pipe so you could remove the system easier if you wanted.
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition
Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
