Chevy & GMC Vans

It's been a long while for me to login and say hi to everyone. Sorry I've been away, hope everyone is doing well. I finally got around to pulling the head off my motor which I had cracked a valve spring. To make a long story short, due to the 480 lift of my cam the rocker studs were working their way out and I was at the limit of max lift anyway without machining the heads. Looking back I should have installed the 0.050 inch keepers for added clearance.

Oh well live and learn, at least there was no catastrophic engine damage. Now instead of reworking the early swirly heads I'm considering on picking up a set of vortec heads and the matching TBI intake. Haven't looked into it, but does anyone know if you need different lenght head bolts for the vortecs? I don't think you do.

Oh of course I'll be getting the vortec's reworked with screw in studs and modified to allow for the cam lift clearance.

Howdy stranger... good to hear from ya.

Hi Chris-good to hear from you again.

Thanks for the hello guys. I can't believe my van has been dorment for over a year! I should be getting it back on the road soon, I do miss it.

I need to try and catch up here to see what everyone has been up too.

Good to see you back. Wish I could help ya but never got around to going Vortec.