Page 1 of 1

Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 8:47 am
by peelers
I apologize if this question has already been posted. I searched but could not find anything. As a result, I'm posting up my dumb a.. question.

2000 Astro
Towing Package

I have owned this van for 6 years and have towed with it for the last 3 years. My question is, the wiring harness located in the jack stow area. The chevy owners manual states to simply open the dutch doors throw your wire harness out and slam the door shut. This is the chevy recommended way to run your wires to your trailer. I have been using this slam the wires in the door method for years and it has never felt like the right thing to do. My question is where is the best place to 'permanently' route your trailer wires? Thru the floor? Thank you.

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 9:56 am
by mdmead
I could never find any trailer wiring on my '96 Conversion, so when I made my own, I actually ran my wires down through the area where the rear tail lights are. It's been years since I did it, but if you pull out a tail light, I bet you can figure a routing. (I think I ended up drilling a hole inside there somewhere.)

In the end I have a loose pigtail that rides up under the back bumper. When I needed it, I just reached up and pulled it out. Stuffed it back up in when done. (Mine is a flat four wire. It would have been easy enough to mount an RV plug, but I didn't need it.)

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 10:18 am
by peelers
ahh.. pull a tail light out... i like that.. i'll pop one out and have a look.

Thank you! :guitar:

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 11:31 am
by astrozam
I remember my 95 had a slight indentation along the sill right where the weatherstripping was cut, this allowed the doors to be closed with no worries of pinching the wire.

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 12:48 pm
by unrreal
peelers i got a 99 and there is a hole in the jack storage area all the way down in that little corner underneath the tail light all you need is a set of needle nose pliers to grab the wires from outside the van and pull them trough... and this hole is there from factory i found it while i was under the van one day and i ran my wires trough there....

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 12:56 pm
by peelers
Sweet! Thanks unreal. I'll give that a look tonight. Thank you. :cheers:

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 1:50 pm
by unrreal
no problem bud, and here are the pics for reference...

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 2:36 pm
by unrreal
and the ones from the bottom...

Re: Trailer Wiring Dutch Doors Question.

Posted: Thu Nov 04, 2010 2:54 pm
by peelers
Wow. Great pictures. Thank you. I really do appreciate it. :cheers: