anyone no how to do this?
Posted: Tue Jan 04, 2011 10:43 am
I am modifying the stock rear bumper and one idea is to run exhaust out through it, does anyone have any idea on how to cut round holes in steel?
Chevy & GMC Vans
The premier site for GM van information
http://chevygmcvans.com/
anyone no how to do this?
Page 1 of 1
Re: anyone no how to do this?
Posted: Tue Jan 04, 2011 11:13 am
Hole saw. Be sure the saw is for steel and not wood.
Re: anyone no how to do this?
Posted: Tue Jan 04, 2011 3:10 pm
Like this...
Hole saw in the correct diameter.
Hole saw in the correct diameter.
Re: anyone no how to do this?
Posted: Wed Jan 05, 2011 5:35 am
that looks great thank you
Re: anyone no how to do this?
Posted: Thu Jan 06, 2011 10:37 am
I like that! Hmmm... I might do that. Looks cleaner than dangling down, and only need the tips to look good. Maybe a few holes for rear facing spotlights? I also like the hole for the trailer wiring, too.
-Andrew
-Andrew