Changes cam sensor, won't start
-
luvmyastro
Topic author - I am merely driving my van
- Posts: 6
- Joined: Thu May 13, 2010 3:56 pm
Changes cam sensor, won't start
I was getting a chech engine light code p0341. Possible cause cam sensor. I changed the cam sensor, dist cap rotor and all plugs. It will not start but fires back like timing is off. Do I need to relearn ICM. Any advise willbe appreciated.
-
Cobra
- I plan to be buried in my van
- Posts: 1750
- Joined: Sat Jun 16, 2007 2:31 pm
- Location: Toronto, Ontario
Re: Changes cam sensor, won't start
did you get the right firing order on the plug wires that would be the most likely possiblility viewtopic.php?f=4&t=35
1998 GMC Safari AWD, BFGoodrich AllTerrain T/A
Jet performance tuner 91 octane preset, Jet under-drive pulleys
Rancho 999000 series shock, on-board controller to be installed later
DHC rock rails and skid plate Add-A-Leaf
G3500 front calipers
Zexel Torsen Diff
11" drums
180 amp Alternator
Long tru-cool 4590 trans cooler
1997 gone
Jet performance tuner 91 octane preset, Jet under-drive pulleys
Rancho 999000 series shock, on-board controller to be installed later
DHC rock rails and skid plate Add-A-Leaf
G3500 front calipers
Zexel Torsen Diff
11" drums
180 amp Alternator
Long tru-cool 4590 trans cooler
1997 gone
-
luvmyastro
Topic author - I am merely driving my van
- Posts: 6
- Joined: Thu May 13, 2010 3:56 pm
Re: Changes cam sensor, won't start
Yes, I have checked and double checked. I will try again because it seems like a timing thing to me, backfires like timing or reversed plugwire. got spark to the plugs so it has to be something stupid like that.