Page 1 of 1
one long one short
Posted: Mon Jun 13, 2011 10:34 pm
by thegreenmachine
yup one long bar one short bar. torsion that is.
wtf. is that even possible???? pics to follow as per rulr 6b.
Re: one long one short
Posted: Tue Jun 14, 2011 4:30 am
by ihatemybike
Possible I guess, but very stupid. Bet someone was too cheap to replace them both when one snapped.
If I discovered that, I'd be replacing both.
Re: one long one short
Posted: Tue Jun 14, 2011 10:11 am
by doyoulikeithere
ihatemybike wrote:Possible I guess, but very stupid. Bet someone was too cheap to replace them both when one snapped.
If I discovered that, I'd be replacing both.
or at the very least change out the long one for a matching short one.
( Me being the cheapo sort that might only do 1, as long as it didnt end in a missmatch)
Re: one long one short
Posted: Tue Jun 14, 2011 1:16 pm
by astroturf
Off to the Junk Yard.
Good Luck, Jim
Re: one long one short
Posted: Tue Jun 14, 2011 9:50 pm
by thegreenmachine
Damn!!! guess i'll be buying a torsion unloading tool, and all the bs that goes with it!!! man my A.D.D. kicked in when ibought this one wow!!!
Re: one long one short
Posted: Wed Jun 15, 2011 5:36 am
by astroturf
Green,
Don't sweat the small stuff. You'll be fne.
Take Care & Good Luck, Jim
Re: one long one short
Posted: Wed Jun 22, 2011 5:23 am
by LiftedAWDAstro
Use a modified "C" clamp...
Pics courtesy of Lockdoc
Re: one long one short
Posted: Wed Jun 22, 2011 3:00 pm
by unrreal
hey green you don't really need an unloading tool or c clamp either to remove the torsion bar, all you need is to relieve the pressure on the bars which can be done by simple lifting the front wheels off the ground, the only reason to use the c clamp is if you want to remove them without lifting the vehicle off the ground...
Re: one long one short
Posted: Fri Jun 24, 2011 7:59 pm
by thegreenmachine
unrreal wrote:hey green you don't really need an unloading tool or c clamp either to remove the torsion bar, all you need is to relieve the pressure on the bars which can be done by simple lifting the front wheels off the ground, the only reason to use the c clamp is if you want to remove them without lifting the vehicle off the ground...
No effin way.!!!???