DoYouLikeItHere's Harem...

[thumbsafari]

how much lift was in the van in the picture labeled in her better days

[doyoulikeithere]

Well, I've never had more than a set of 2 inch body lift blocks in the front. I cranked up the torsion bars to get about another 2 inches max.

The back had sagged out steel springs with OLV lift shackles that give about 2 or 3 inches or so. That didnt do it, so I also put in 2 inch axle blocks. I think thats whats in the pix. I eventually nixed those blocks, and just got good springs that give about 4 inches of lift.
Then with the OLV shackles on their lowest rung, sat about another inch up from as in those pix.

[doyoulikeithere]

Ok time for more pix.

Here she sits finally on her own wheels.
2 inch body lift in front, with mildly turned up torsion bars for about 3-4 inch front.
OLV Shackles and NO blocks, with S-10 springs I got locally. they had about 7.5 inches of free arc.
I almost think I should put stock shackles back in it to level it out.

Posi Lock cable to lock hubs on the fly on my S-10 front axle.

I made this adapter to lift my transmission mount up by about 1-3/8 inches. The engine got lifted 2 inches at the mounts. Should line up to the trans pretty good, and allow the front driveshaft to clear the crossmember and the clutch cylinder.

[doyoulikeithere]

Pix of the brace bar I made.

[GnarliSafari]

nice looking collection!

[doyoulikeithere]

She finally went for the maiden voyage tonight.
Up the highway and back for a couple miles with no plates
Tomorrow it gets plated.
Sure has some new power! I can hardly wait to drive to work tomorrow!
I think I might twist the torsion bars up just a tiny bit more, and reinstall the stock shackles instead of the overlands that are on there in the pic.

[loopie]

Good stuff!
Yup...agreed, I think it'll look better without so much of a height difference front-to-rear.

[doyoulikeithere]

Well, It stopped raining, so tonight I cranked up the t-bars to the top and then backed them both off 1.5 turns.
Then I Measured it and tightened the passenger side up half a turn.
Both front wheel wells at top center measure 34 inches now, and the rears are 35 with the overland shackles on the lowest rung.
Sits a lot closer to level now, so I will leave the overlands in there.

[doyoulikeithere]

this looks a bit better.

[MountainManJoe]

Looks pretty good. Is that lake Cowichan?

[doyoulikeithere]

Yup, sitting right on the peninsula, looking north at Youbou.
My buddy showed where the road is to the "Scout Camp" (pictured) So, Guess where the kids are going fishin next weekend!!

[LiftedAWDAstro]

Nice van! I like the sound of it when you were rowing through the gears in the video.

[doyoulikeithere]

Thanks,
I will have to post another vid that actually does justice to the sound!

I gotta find my tripod first so I can do it hands free!!

[doyoulikeithere]

She's been doing her daily driver service for well over a month now. A few little bugs to work out. Getting a front driveshaft finally, tommorow. Then i can take it further up the hill.

[loopie]

That's lookin great! Loopie like.
What size tire in the last pic again? I can't recall....