I'd like to swap the 2nd row buckets from the 93 into the 94...
upon closer inspection late last night I see there are two extra mounts in that row. without pulling up the carpet.. what's under there?? .. can these extra two anchors and trim be popped into the 94? .. or am i looking at cutting holes in the floor to mount these puppys?
thanks.. yet again..
rob
2nd row seating mount question..
-
Topic author - I plan to be buried in my van
- Posts: 1289
- Joined: Thu Sep 21, 2006 11:18 am
- Location: Woodstock, Ontario
2nd row seating mount question..
Rob
current rides:
04 Mazda 6 V6 5spd
vans owned:
97 Astro AWD (selling by summer .. i think) SOLD
99 Astro LS Sept 08 ASV VOM
94 Astro LT
93 Astro LT
96 Astro LT AWD * parts van*
current rides:
04 Mazda 6 V6 5spd
vans owned:
97 Astro AWD (selling by summer .. i think) SOLD
99 Astro LS Sept 08 ASV VOM
94 Astro LT
93 Astro LT
96 Astro LT AWD * parts van*
the holes to cut are prestamped on the floor of your van, so yeah, you'll probably have to cut them out, but you already have the lines drawn.
(in best PeeWee Herman voice--"connect the dots, la, la, la, la)
My DH says that the cups will have to be then bolted or rivetted into place.
(in best PeeWee Herman voice--"connect the dots, la, la, la, la)
My DH says that the cups will have to be then bolted or rivetted into place.
03 "Pewter" Astro AWD stock
early 90s Astro currently under the knife
early 90s Astro currently under the knife
-
Topic author - I plan to be buried in my van
- Posts: 1289
- Joined: Thu Sep 21, 2006 11:18 am
- Location: Woodstock, Ontario
that was a disturbingly well done impression gurl..
thanks!
thanks!
Rob
current rides:
04 Mazda 6 V6 5spd
vans owned:
97 Astro AWD (selling by summer .. i think) SOLD
99 Astro LS Sept 08 ASV VOM
94 Astro LT
93 Astro LT
96 Astro LT AWD * parts van*
current rides:
04 Mazda 6 V6 5spd
vans owned:
97 Astro AWD (selling by summer .. i think) SOLD
99 Astro LS Sept 08 ASV VOM
94 Astro LT
93 Astro LT
96 Astro LT AWD * parts van*
Rob, my 89 Safari only had the middle seat, not the rear one. I checked to see if the floor cups were there for the rear seat--no dice, the factory never installed them.
I've seen a junked Astro that had had the floor cups removed via a hammer and a chisel; somebody must've wanted to add seats to a cargo van.
I've seen a junked Astro that had had the floor cups removed via a hammer and a chisel; somebody must've wanted to add seats to a cargo van.
Rob Shaver
1989 Astro 305 with an MSD 6A ignition and a dash-mounted MSD timing control, a 4160 Holley 465 cfm four barrel carb, and an HEI distributor.
Moog 625 front springs and Energy Suspension poly bushings. Rear OEM sway bar. Edelbrock shocks.
1989 Astro 305 with an MSD 6A ignition and a dash-mounted MSD timing control, a 4160 Holley 465 cfm four barrel carb, and an HEI distributor.
Moog 625 front springs and Energy Suspension poly bushings. Rear OEM sway bar. Edelbrock shocks.