Chevy & GMC Vans

TheChopFather wrote:make your own! they are easy to do. heres a print for you....

Are these AWD or RWD mounts?

RWD engine mount plans.

Does anyone have AWD mount plans I could use? [-o<

hi 2 you all im a new member from sweden :P

im in need of some plans of the motormounts like the one posted in here...but when im printing them....the size in a bit of...what is the right pirnt size for the plans/blueprints???

Hey Gord, How are ya?

Dont think I've seen ya round before but you were here before me no doubt.
Anyways, After I read about you wanting to Turbo a Propane engine, it reminded me of this other thread I read a few days ago.
Its called turbo 4.3 swap, and its propane...
http://monkeycage.island4x4.com/showthr ... post479281
Good luck, it sounds like fun.

RickU wrote:Does anyone have AWD mount plans I could use? [-o<

X 2 on that!!

Belsebub wrote:hi 2 you all im a new member from sweden :P

im in need of some plans of the motormounts like the one posted in here...but when im printing them....the size in a bit of...what is the right pirnt size for the plans/blueprints???

Welcome.

You could print it on any size, as long as you use a ruler to measure and mark it out on the steel plates before you cut them.
I think all the measurements are shown.

AWD van mounts are not the same.

tnx for the welcome

My astro is an rwd....i looked at the motormounts for the awd and they are complitly diferent from the rwd ones...maby my next astro gona be an awd....but i love to have rwd.....allmost all cars these days are fwd.....and whats the fun in that ...a car must have rwd and a v8 to be an real car do
the motor mounts are gona be cut out later this week :P

and tnx for the fast reply btw and a great forum