Chevy & GMC Vans

i need to replace my steering column in my 90 astro, with a 4.3,2-wheel drive, tilt, any help would be appreciated! thank you

Astroken wrote:i need to replace my steering column in my 90 astro, with a 4.3,2-wheel drive, tilt, any help would be appreciated! thank you

Its just So Easy!
1 bolt under the hood separates the column from the shaft.
4 (or so) small screws hold the plate against the floor.
2 bolts hold the column up under the dash by your knees, let it drop.
Unplug the wire plugs on the column.
Pull.....
If the new column has more options than the original, no biggie, they just probably wont work if you didnt have already.
Eg: If New column has cruise control but your van never did, it isnt going to magically Start to work, but it wont hurt anything.
However, you want to be sure your new column has the options your van did, or the CC you used to have wont work with a column that has no CC controls on the turn signal stick. I guess you could swap the turn signal stick too though.
Tilt or no tilt, either can replace the other.

Here is a link of when I did mine:

viewtopic.php?f=5&t=2672&p=26806&hilit= ... ing#p26806

Thank you very much for all the help and info. My son and I can't wait to get started!

viewtopic.php?f=5&t=4056&p=41902&hilit=logan#p41902

My install with pictures. :-)

Just wanted to say thank you for all the help. got the column changed out, and it's running great!
took about 1 1/2 hrs. not bad. you guys rock!!!
THANKS again. pic coming soon

Hey all!
I know its an old thread but I was wondering if the 96 column was the same as the column change in this thread.
I have to go pull one today and want to be sure of what I am after.
Is my 96 a mechanical linkage or a cable?

Found it.